Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Parts for Brighton Homeowners
When a garage door starts dragging, squealing, or hanging crooked, the problem is almost always a worn component, not the whole door. Finding the right replacement part for your exact make is where most homeowners get stuck, and it’s exactly what we do. Our technicians have up to 15 years of experience sourcing and fitting parts for the systems used in Brighton’s triple-deckers, brick colonials, and newer condo buildings, from torsion springs to bottom seals. We carry and source common components directly, so you’re not waiting on a special order or a handoff to another company. Garage doors are all we do. Call (877) 492-3662 and we’ll get a technician out, often the same day.
What Our Garage Door Parts Service Includes
Every part on a garage door wears on its own schedule. We diagnose which one is failing and replace just that component, or the set that needs to move together, so you’re not paying for a full door when a hinge and a set of rollers will do the job.
Torsion Spring
A torsion spring is the coiled steel bar mounted above the door that counterbalances its weight. When it snaps, the door becomes dangerously heavy and usually won’t open at all. We replace torsion springs matched to your door’s weight and track, and we never recommend reusing an old spring alongside a new one, since mismatched springs wear unevenly and fail early. This is high-tension work, so we handle it with proper winding bars and the door locked out. A typical torsion spring replacement in Brighton runs $180 – $340 for one spring, and a matched pair costs about twice that because both are usually replaced together.
Extension Spring
Extension springs run along the horizontal tracks on either side of the door and stretch as the door closes. They’re common on older Brighton garages and are more prone to sudden failure than torsion systems, which is why we check the safety cables that should run through each spring. If a cable is missing or frayed, we fit a new one at the same visit. We source extension springs in the correct weight rating for your door rather than a generic size that will sag or overstress the opener.
Cables & Drums
The lift cables wind around drums at each end of the torsion bar and do the actual lifting. A frayed cable, a slipped drum, or a door that hangs crooked on one side usually points here. We replace cables in matched pairs and reset the drums so the door lifts evenly, because a single new cable against an old one throws the whole system out of balance. Cable repair in Brighton typically runs $130 – $250.
Rollers & Hinges
Rollers ride inside the track and hinges connect the door panels. When rollers wear flat or hinges loosen, the door gets noisy, jumps in the track, and strains the opener. We replace rollers and hinges as a set so the door travels smoothly, and we check the track alignment while we’re in there. Roller replacement usually falls in the $110 – $220 range depending on door size and roller type.
Weatherstripping
Weatherstripping seals the gaps around the door frame and between panels, keeping out drafts, rain, and pests. In Brighton’s older housing stock, worn weatherstripping is a common source of winter drafts and water intrusion at the jambs. We fit new strips sized to your frame so the door seals evenly without binding.
Bottom Seal
The bottom seal is the rubber or vinyl strip along the floor edge of the door. When it cracks or flattens, you get drafts, water creeping in during heavy rain, and small animals finding a way in. We replace the seal with a profile that matches your door’s channel and sit it flush to the floor so the door closes tight without dragging.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Parts
Parts aren’t universal. A LiftMaster opener calls for different components than a Genie, and a Raynor door uses hinges and rollers built to its own panel profile. That’s why we learn the equipment, not just the trade. We service LiftMaster and Chamberlain openers regularly and know where their drive gears and travel modules wear out first. We also work on Genie and Raynor systems and can match the right replacement parts to the model already on your door.
That brand fluency matters most when a part fails and you need the right one the first time, not a generic substitute that fits loosely and fails again in a season. Whether you have LiftMaster, Chamberlain, Genie, Raynor, or any other make, we can help. If you want to see the full range of components we handle, our garage door parts page covers the details.
Signs You Need Garage Door Parts Right Now
- A loud bang from the garage. A torsion spring snapping sounds like a gunshot. If you heard it and the door won’t lift, stop pulling on it and call us. A door with a broken spring is dangerously heavy.
- The door lifts crooked or binds in the track. This usually means a worn cable, a slipped drum, or a failing roller. Left alone, it strains the opener and can bend the tracks.
- Grinding, squealing, or rattling as the door moves. Dry or flat rollers and loose hinges are the usual culprits. Replacing them early is cheaper than replacing an opener later.
- Daylight or drafts around the door edges. Failing weatherstripping and a worn bottom seal let in cold air, rain, and pests. It’s a quick fix that pays off through a Brighton winter.
- The door reverses or stops partway. Sometimes it’s the opener, sometimes it’s a binding part dragging on the door. We check both so we fix the actual cause.
Our Garage Door Parts Process – Step by Step
- 1
We diagnose the whole system, not just the symptom. A technician inspects the springs, cables, drums, rollers, hinges, and seals, and runs the door by hand to feel where it binds. We check the opener’s balance and travel too.
- 2
We identify the exact part and brand. We match the component to your door’s weight, model, and make, whether that’s a LiftMaster opener or a Raynor panel set. No guessing with generic sizes.
- 3
You get a written price before we touch anything. We explain what’s failing, what it costs, and whether a repair or a full replacement makes more sense. The price is quoted and agreed before any work starts.
- 4
We fit the part and rebalance the door. After replacement we cycle the door several times, check the spring tension, and confirm the door runs smooth and even in the track.
- 5
We show you what we did and what to watch. You’ll know which parts were replaced and what to listen for going forward, so you’re not guessing next time something sounds off.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Parts Cost in Brighton?
Parts and labor together, most jobs land in a predictable range. A typical torsion spring repair in Brighton runs $180 – $340 for one spring, and a matched pair costs about twice that since both are usually replaced together. Cable repair runs $130 – $250. Roller replacement sits between $110 – $220. A panel replacement, when a door section is dented or cracked, runs $250 – $500. If the problem turns out to be the opener rather than the door, opener repair runs $120 – $320.
What moves the price: the type and weight rating of the part, whether it’s a paired replacement, the door’s size, and whether the tracks need realignment too. You avoid overpaying by getting the cause diagnosed properly rather than replacing parts at random. Every free estimate includes a full inspection, a written price on the exact parts needed, and a clear answer on whether repair or replacement is the smarter move. The written estimate sets the final price, so there are no surprises when the work is done.
Garage Door Parts Near Brighton – Our Service Area
We serve Brighton and the surrounding neighborhoods, including Allston, Brookline, Watertown, Cambridge, and Newton. If you’re just over the line in Allston, our garage door parts team covers that area too, and Brookline homeowners can reach the garage door parts service directly. Response times depend on the day, but we aim to get a technician out quickly for parts and repair calls.
Serving Brighton, MA – Our Local Coverage Area
We serve Brighton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Parts in Brighton
Garage door parts are the components that make the door and opener work: torsion and extension springs, cables and drums, rollers, hinges, weatherstripping, and the bottom seal. We source and fit all of these, plus the parts inside your opener. If a single component is failing, replacing just that part is often all you need.
Most parts replacements take one to three hours, depending on the component. A spring or cable replacement is faster; a panel replacement or a job that needs track realignment takes longer. We give you a time estimate when we confirm the appointment.
Typical ranges run $110 – $220 for rollers, $130 – $250 for cables, and $180 – $340 for one torsion spring, with a matched pair about twice that. A written estimate sets the final price before any work starts. Call (877) 492-3662 for an exact quote, and estimates are free.
Yes. We service LiftMaster and Chamberlain openers and their components, along with Genie, Raynor, and other major makes. We match the replacement part to your exact model so it fits and performs the way it should. If you’re unsure of your brand, we can identify it during the inspection.
In most cases, yes. A door that won’t open because of a broken spring or cable is a priority call, and we aim for same-day service in Brighton. Call us as soon as you notice the problem and we’ll get a technician scheduled.
We stand behind the parts and labor we provide, and we’ll walk you through what’s covered on your specific job. Ask your technician for the details on your estimate before the work starts. That way there’s no ambiguity later.
Clear the area in front of and around the door so the technician has room to work, and note any noises, sticking, or reversing you’ve noticed. Have your door and opener brand or model number handy if you know it. If the door is stuck open or damaged, don’t force it, just let us know when you call.
Schedule Your Garage Door Parts Service in Brighton Today
A worn part doesn’t fix itself, and a small failure often leads to a bigger one. Call (877) 492-3662 for a free, no-obligation estimate. We’ll diagnose the problem, quote a written price before any work starts, and fit the right part the first time. At Brighton Garage Door Repair Pros, we handle doors, openers, springs, and parts under one roof, and our technicians are ready to help.
Written by the team at Brighton Garage Door Repair Pros.